| Author |
Message |
Posted by:
Mark McFadden
Tuesday, November 03, 2009
10:35 am | I have an 08 GL1800 with an 09 CSC Trike kit. I recentlty installed a rear spoiler which is currently wired up as a brake light only. I purchased one of those wiring kits to hook it up to run as a tailight as well as a brake light. I know the upper connection is the one on the trunk lid. But where in the heck do I go to hook up the lower end of the connector?? Any Trikers out there who can help?? 
(Message edited on November 03, 2009)
Mr. Fixit
Shriners Hospitals For Children Are There to Help. Know A Child with Burn or Orthopedic Injuries. Contact a Shriner in Your Area or Feel Free To Contact Me!!! |
Posted by:
Bill McRoberts
Tuesday, November 03, 2009
03:17 pm | Mark,
The connectors that are originally behind the license plate on a Wing are in the same general area. You have to remove the lower trunk cover. It is the piece of "tupperware" on the bottom side of the trunk. After you get it removed, you will find the conectors down behind the CSC trunk. You may have to fish around in there to find them. That's where they are on my '06 CSC.
Bill McRoberts
retired Bellsouth
retired SC Dept of Corrections
'06 Titanium GL1800(3)with CSC conversion
'03 CSC Escapade Elite trailer
bmr4106 at bellsouth dot net
Iron Butt Association
Former Chapter Educator SC-P
  ,
Pray for our soldiers, our country and our President |
Posted by:
Mark McFadden
Tuesday, November 03, 2009
08:23 pm | Bill,
Thank you very much for the assist. I guess this will be my weekend project! Great to finally be a member and wishung you a great week!
Mark
Mr. Fixit
Shriners Hospitals For Children Are There to Help. Know A Child with Burn or Orthopedic Injuries. Contact a Shriner in Your Area or Feel Free To Contact Me!!! |
Posted by:
Leon Stearns
Tuesday, November 03, 2009
08:42 pm | Mark - Both connectors should be under the top lid cover in the upper trunk inside a vinyl boot. One is the stop light wire and the other is hot with the ignition on. At least that is how my 06 is wired. You have to remove the inside cover of the trunk lid. You will see all the screws when you open the trunk. These have to be removed to drop the inside cover down. Watch for different lengths of the screws and remember where they go.
PIF FREEDOM BOARD |
Posted by:
Al Trimm
Wednesday, November 04, 2009
04:47 am | "Watch for different lengths of the screws and remember where they go."
If you don't do this you will have two little dimples in your trunk just like mine. |
